Downloaded from https://www.everyspec.com MIL-HDBK-802(SH) 2 July 1990 7.3 Armature circuit. 7.3.1 General. The armature current in a minesweeping generator is large. It flows in complicated circuits in the machine and, unless these circuits are carefully designed, can produce a large stray magnetic field. The armature current flows in the following: (a) Armature winding. (b) Commutator risers. (c) Commutator bars. (d) Brush rigging. (e) Connections from the brush collector rings to the commutating winding, the compensating winding and the machine’s terminals to an external circuit. (f) Commutating winding. (g) Compensating winding These circuits will be grouped and treated as follows:
(a) The armature winding, commutator risers, commutator bars, brush rigging, and the brush collector rings will be grouped together and then divided into the various arrays of current loops that will give the same magnetic field as the current actually flowing in the machine. (b) The connections from the brush collector rings to the commutating winding, compensating winding, and external circuit will then be discussed, (c) Finally, the commutating winding and the compensating winding will be discussed.
7.3.2 The armature circuit from the armature winding to the brush collector - - We will confine our attention to a four-pole generator in our consideration of the armature circuit from the armature windings to the brush collector rings. This does not mean four poles are enough for a minesweeping generator. We can use a four-pole machine as an example because it has enough poles to illustrate the points that are involved. The use of a larger number of poles would complicate our equations and discussion without adding anything essential to our insight into the principles of designing a generator having a small stray magnetic field. 7.3.2.1 Simplifying assumptions.
A number of simplifying assumptions are made in order to bring our problems down to manageable proportions even for the fairly simple case of a four-pole generator. These assumptions include the following: (a) The armature has a lap winding but no equalizer connections (also known as armature cross connections). (b) The number of commutator bars is an integral multiple of the number of poles. (c) At all times, each set of brushes makes contact. with only one commutator bar. (d) Lath set of brushes touches the commutator bar with which it makes contact at only one point. 130