NAVSEA MIL-HDBK-802(SH) — MIL-HDBK-802(SH) Design of Electrical Equipment with Small Stray Magnetic Fields Manual PDF

Downloaded from https://www.everyspec.com (e) The connection from a set of brushes to the brush collector ring is directed radially outward from the point of contact with a commu- tator bar to the point of connection to the brush collector ring. Some of these conditions could be satisfied in an actual machine and some could not. It is possible that none will be satisfied in a particular minesweeping generator.

We are, therefore, considering an idealized machine for the purpose of obtaining a simplified over-all picture of the stray magnetic fields that will be produced by the flow of armature current from the armature winding to the brush collector rings, inclusive, Having done this, we can then proceed to examine what modifications of this simplified picture would be made necessary by dropping the simplifying assumptions. 7.3.2.2 Developed view of a machine. Consider the armature of the machine and the brush collector rings. The armature winding and the commutator are on the surfaces of two coaxial cylinders The brush collector rings are circles concen- tric with the cylinders.

Imagine that the whole structure is slit lengthwise, laid out flat, and that the parts of greater diameter than the commutator are simultaneously shortened so that equal lengths in the direction between points 5 and 8 of figure 75 correspond to equal angular spread between points when in the positions actually occupied in the machine. This procedure gives us the developed view shown on figure 75. In this view, all commutator bars are shown of short length except those with which the brushes make contact at points 6, 8, 9 and 10. All bars not touched by a brush carry no current and require no consideration in a discussion of current paths.

To complete the circuit and permit current flow in the armature, commutator risers, commutator bars, and brush collector rings, the two brush collector rings are connected between points 11 and 12. These are the points at which the armature current leaves one brush collector ring and returns to the other. They will be referred to as the takeoff points. Note that the takeoff points have an angular spread of b-a degrees. It will appear later that there will be a longitudinal component of magnetic moment unless this angular spread is zero. FIGURE 75. Developed view of armature winding commutator and brush collector rings. 131