Downloaded from https://www.everyspec.com 7.2.2.3 Determination of currents. The straightforward way of determining the currents in the armature winding and other parts of the circuit would be to assume that e~ are the unidirectional voltages induced in the four parts of the armature winding between adjacent sets of brushes; assume values for the resistances of the four sets of brushes and other elements in the circuit; and then proceed to calculate the currents.
In the ideal case of a perfectly symmetrical generator with exactly equal poles, all four Induced voltages will be equal in magnitude and alternately plus and minus in sign if voltage is counted positive in one direction around the armature. In an actual generator the induced voltages may not all be equal because of differences in pole strength, and they el, ez, es, and should , therefore, be assumed to be unequal. Note, however, that the four induced voltages cannot all be chosen arbitrarily but are subject to the condition that:
This equation says that if we start at any point on the armature winding and proceed around it until we come back to the starting point, the total induced voltage will be zero. We can see this in a number of ways. Perhaps the simplest is as follows. The flux-cutting conductors of the armature winding are represented by twelve sets of two adjacent vertical lines in figure 75. The two lines represent two conductors or coil sides in the same armature slot; they cut the same magnetic flux; hence, the same voltage will be induced in each, The voltage induced in one will be in a clockwise direction around the coils of the armature winding, in the other, in the reverse direction.
Since the two induced voltages are equal and opposite, the net voltage is zero. The same will be true for all the other pairs of flux-cutting conductors and the net induced voltage all around the armature winding will be zero. We can, therefore, assume arbitrary values for only three voltages, for example e3. The fourth voltage will be ez. If we now proceed in a straightforward manner to solve for the currents, we will ultimately come up with expressions for the currents in terms of e~ - - el - es - el, ez, and es, and resistances.
It can be done this way, but a considerable amount of algebra is involved and the results are in a less immediately usable form than if an alternative procedure is used. This is to start out by assuming the currents in three of four brush sets (only three currents can be chosen arbitrarily, as shown herein) and then solve for all other currents in terms of these three. This is the procedure that will be used. e], ez, 7.3.2.4 Currents in commutator bars.
In the ideal case, each of the four sets of brushes would take the same current and the currents in the four commutator bars they touch (those between points 1-9, 2-6, 3-10, and 4-8) would be equal in magnitude and have the directions shown on figure 75. In actual machines, however, the different sets of brushes do not take the same current. To take this into account, we will assume that the currents in the four commutator bars touched by the brushes are as shown on figure 75. Three of these four currents, 8A, 8B, and 8C, can be chosen arbitrarily. The fourth current q ust then be 8(A + B - C) to make the current returning to the armature winding equal to the current leaving it.
The current output of the machine is 8A + 8B, which is the current in the connection between points 11 and 12. 132