NAVSEA MIL-HDBK-802(SH) — MIL-HDBK-802(SH) Design of Electrical Equipment with Small Stray Magnetic Fields Manual PDF

Downloaded from https://www.everyspec.com MIL-HDBK-802 (SH) 2 July 1990 7 .3.2.5 Currents in armature winding. in the armature winding. These currents can the currents to point 1 must be equal to the IL be the currents be calculated as follows: The sum of sum of the currents away hence, 1 1 + points 2, 3, and 4 we have the four Let 11, 12, Is, and x~ - 8A. Applying the same consideration to following equations: Here are four equations in four unknowns, but only three of them are independent. One more equation is needed. It is obtained as follows: Start from point 2 and follow current II up and to the right. It ultimately ends at point 1.

Doing the same for other points, we arrive at the simplified layout of armature currents on figure 76 in which the points 1, 2, 3, and 4 are shown on a circle in the position they actually have in the machine rather than the positions shown in the developed view of figure 75. Now start at point 2, proceed counterclockwise, and write the equation saying that the total potential drop is zero starting from any point and returning to the same point. This equation is: where: R = resistance of that part of the armature winding through which current II flows. This will also be equal to the resistances through which 1A flow.

E = generated emf in the armature winding counted positive in a counterclockwise direction from point 2 all the way around and back to point 2. 12, Is, and However, E is equal to zero. The generated emf in one direction is equal to that in the other with the result that net emf is zero. Putting E = O in equation 7-6, it reduces to: FIGURE 76. Currents in armature winding. 133