NAVSEA MIL-HDBK-802(SH) — MIL-HDBK-802(SH) Design of Electrical Equipment with Small Stray Magnetic Fields Manual PDF

Downloaded from https://www.everyspec.com MIL-HDBK-802(SH) 2 July 1990 The equation added to any three of the four equations 7-8 to 7-11 enables us to find the four armature currents. They are as follows: For the simple armature winding shown on figure 75 the currents in the armature are uniquely determined, as shown above, when the currents in the commutator bars are known or are assumed. We will proceed with the discussion using these values for the currents in the armature winding, and later on (see 7.3.2.9) consider the modifications that must be made to take into account the equalizer connections that an actual lap wound armature will have. 7.3.2.6 Currents in brush collector rings.

As pointed out in 7.1.3, the brush collector rings will be complete rings of uniform cross section throughout. When this condition is satisfied, the resistance of a brush collector ring between any two points is directly proportional to the angular separation between the points. Consider the brush collector ring that passes through points 5, 6, 7, and 8 of figure 75, and write the equation that states that the total potential drop around the ring is zero. Since there is no generated emf, the total potential drop is the sum of the products obtained by multiplying each current by the resistance through which it flows, hence: where: r = resistance of one degree arc of the brush collector ring.

a = angular spread in degrees between points 6 and 11 of figure 75. Now divide the above equation by 90 r, and let a/90 - c. The result is: This equation is used in connection with equations for any two of the three junction points, 6, 11, and 8, to obtain the three currents in the brush collector ring. The values obtained are shown on figure 77. The currents in the other ring are obtained in a similar fashion and are also shown on figure 89. In the expression for these currents, d = b/90. 134