NAVSEA MIL-HDBK-802(SH) — MIL-HDBK-802(SH) Design of Electrical Equipment with Small Stray Magnetic Fields Manual PDF

Downloaded from https://www.everyspec.com MIL-HDBK-802(SH) 2 July 1990 components on the coordinate axes. In the rectangular coordinate system, the vector can be resolved into x, y, and z components that will be designated as ~%, ~, and ~ component could be represented by a dipole parallel to the x axis. Mz. Each component can be represented by a dipole parallel to that particular coordinate axis, that is, the 4.2 1.2.3.1 Vertical component The vector component of greatest importance in the design of minesweepers is the vertical (MZ) component.

The reason for our interest in the vertical component is that if we design the electric circuits and equipment such that the vertical component of their stray magnetic field is small at all points on a horizontal reference plane below the equipment, then we can be sure that all three components of the stray magnetic field will be small at all points below the reference plane. 4.2.1.2.4 of an inclined Magnet ic moment of an inclined current loop. The magnetic moment current loop can be calculated as follows: (a) (b) (c) Compute the magnetic moment of the equivalent dipole. Resolve the magnetic q oment into its MZ components.

Calculate the magnetic fields produced by the X, Y, and Z dipoles using the corresponding magnetic moment component from (b), and add the results. The sum will be the magnetic field produced by the inclined current loop. Note that the inclined current loop is first replaced by its equivalent dipole and that this is, in turn, replaced by X, Y, and Z dipoles. The reason for proceeding in this way is that it enables us to calculate the magnetic field from any small, simple current loop by making use of the formulas for X, Y, and Z dipoles. It is not necessary to have special formulas for inclined current loops. ~, ~, and Magnetic fields of noncoplanar current loops.

Consider the noncoplanar current loop ABCDEF shown on figure 17 (A). Part of this loop is in a horizontal plane and part in a vertical plane. Imagine that the loop is opened at points C and F and that two hypothetical conductors are introduced between C and F to make two loops as shown on figure 17 (B), and that the same current exists in the horizontal loop ABCF and the vertical loop CDEF as in the original loop ABCDEF of figure 17 (A). The two hypothetical conductors between C and F of figure 17 (B) carry equal currents.

Since they are purely hypothetical conductors, they can be imagined to be as close together as we wish, Their magnetic fields cancel completely if we assume them to be coincident; hence, the magnetic field produced by the two loops ABCF and CDEF will be exactly the same as that produced by the 4.2.1.2.5 single loop ABCDEF. We can, “therefore, figure the fields of the two loops separately and add them to obtain the field of the original noncoplanar loop.