NAVSEA MIL-HDBK-802(SH) — MIL-HDBK-802(SH) Design of Electrical Equipment with Small Stray Magnetic Fields Manual PDF

Downloaded from https://www.everyspec.com MIL-HDBK-802(SH) 2 July 1990 (1) The array of 4.3.3.12. (2) The array of 4.3.3.13. 4.3.5.2 Compensation using arrays of dipoles producing the same vertical magnetic field. Take two different arrays of dipoles which produce the same vertical magnetic field. By opposing one against the other, they compensate and give zero magnetic field to the degree of approximation considered here. Note , however, that this does not mean absolutely zero field. The formulas given above are based upon a power series expansion for the stray magnetic field from a single dipole or from arrays of dipoles.

The only term used in the approximate formulas is the first term which does not vanish, At a sufficient distance from the arrays, the higher order terms are small, in comparison to the first term which does not vanish, and can be neglected When two different arrays give the same magnetic field to the degree of approximation considered, all that is meant is that they both have the same first term in their series expansion, but the higher order terms do not cancel and we are left with a magnetic field different from zero. 4.3.6 Calculation of magnetic field using Taylor’s series expansion.

The magnetic field produced by an array of an even number of dipoles grouped closely about the origin of the coordinate system where the distance from the dipoles to the origin is small (one-tenth or less) when compared to the radial distance to the point where it is desired to compute the magnetic field component can be determined by expanding a function, F(x,y,z), in a Taylor series (see appendix A). The Taylor series expansion for a function of three variables is given as follows: what points on a plane z meters below the center of the array the vertical component of the magnetic field will have its maximum value, and what this maximum value will be.

To do this, it is convenient to introduce variables C and 6 and redefine x and y as follows: