Downloaded from https://www.everyspec.com MIL-HDBK-802(SH) 2 July 1990 We will demonstrate how the redefined x and y values are used to determine the magnitude and location of the maximum by solving equation 4-81 for its maximum. By making this change in variables, the equation becomes: or by using the trigonometric identity (see table XXIII of appendix A) we obtain: 1 and when C has a value which maximizes sin24 will occur when This equation will have a maximum value when C2(6 - C2)(1 + CZ)-A-S. The maximum value of sin2& - ~ 6 - 45 degrees, 135 degrees, 225 degrees, or 315 degrees.
To find the maximum value of C we must first differentiate equation 4-131 with respect to C and set the derivative equal to zero. The result is: The values of C which satisfy this equation are: For these values of C, equation 4-137 will have either a maximum, minimum, or a point of inflection.
A little consideration shows that it has a minimum value of zero at C = 0, a maximum value of 0.0528 at C = ~ 0.517 and a minimum value (maximum value of absolute magnitude) of -0.00009 at C = 8 = 45 degrees, 135 degrees, 225 degrees, or 315 degrees, at which points the vertical component of magnetic field has the greatest magnitude anywhere on a plane z meters below the center of the array, Making use of the preceding values of C and substituting them into the equations relating C and x and C and y yields: f 2.99. The only values in which we are interested are C = ~ 0.517 and 5.
PRINCIPLES OF DESIGNING EQUIPMENT AND CIRCUITS FOR MINIMUM STRAY MAGNETIC FIELD 5.1 General The preceding section shows that: (a) The magnetic field produced by a current loop is proportional to its magnetic moment, ANI, where A is the area enclosed by the loop, N is the number of turns, and I is the current in the loop.