Downloaded from https://www.everyspec.com MIL-HDBK-802(SH) 2 July 1990 5.8 Principle of self compensation. The principle of self compensation means simply that each individual piece of equipment should be compensated by itself. The principle should be applied to each minesweeping generator, disconnect switch box, contactor panel, circuit breaker, or other component used in the construction of the larger items of equipment.
The principle of self compensation should be applied to all items, large and small, because if each item is individually compensated so that its stray magnetic field is small , then the stray magnetic field from all the equipment on the ship will be small, regardless of whether some or all of the equipment is in operation 5.8.1 Orientation. Some equipment, such as minesweeping generators, large contactor panels, and switchboards are designed and built for installation with only one orientation. A minesweeping generator, for example, is built for installation with its axis ‘horizontal, and cannot be stood on end and installed with its axis vertical.
Smaller items of equipment, however, may be installed in several different ways depending on the available space and the arrangement of other equipment on the ship. For all such equipment, the principle of self compensation should be applied so that the stray magnetic field below the equipment will be small regardless of its orientation. Normally, the vertical component of the magnetic field at a given distance below. the equipment will vary with the orientation of the equipment. It might be extremely difficult or even impossible to design the equipment so that the stray field is independent of orientation. Fortunately, this is not necessary.
All that is necessary is to make sure that the largest stray magnetic field for any orientation is small enough to be acceptable. If this objective is attained, the ship designer and shipbuilder will have greater freedom in arranging the equipment. 5.9 Principle of mutual compensation. The principle of mutual compensation is applicable when there are two or more pieces of the same equipment installed on the ship. This involves connecting the pieces of equipment so that the stray magnetic field of one opposes that of the other. 5.9.1 Utility. The utility of the principle of mutual compensation can be illustrated by considering the case of a minesweeper with two minesweeping generators.
The first objective is to use the principle of self compensation to make the stray magnetic field of each generator as small as possible. Having done this , there are still two generators, which can be used either alone or in parallel and which have stray magnetic fields different from zero. These two generators can be connected so that their stray magnetic fields add, or, in accordance with the principle of mutual compensation, so that they oppose. When the two generators are used in parallel, we get approximately twice the magnetic field of one in the first case, and perhaps less Than the magnetic field of one in . . . the second case. This has been observed on a number of minesweepers.
Therefore, there is a substantial improvement obtained by using the principle of mutual compensation. At the same time, the principle of mutual compensation is secondary to the principle of self compensation. The most important concept is that of making the stray magnetic field from each generator as small as possible. This is necessary to minimize the stray magnetic field when only one generator is in use, as well as when both are in use. If each generator, individually, has a large stray magnetic field, the two together could have a stray magnetic field that would be too large even if we use the principle of mutual compensation Mine - sweeping generators are large machines:
they cannot be placed very close together. 78