NAVFACENGCOM MIL-HDBK-1001/l — NAVFACENGCOM MIL-HDBK-1001/l: Руководство по архитектурным требованиям и принципам проектирования

Downloaded from https://www.everyspec.com MIL-HDBK- 1001/1 G to sound. The alarm hardware panel and with alarm can only be silenced by an authorized key. Panic and is available with contacts for signaling to a remote indicating outside key control to permit authorized entry. c) Remote Indicating Panels and Door Switches. Indicator panels allow remote monitoring of doors connected to the console. Light and buzzer signals indicate whether doors are locked, open, or violated. The channel indicating the intrusion cannot be reset until correction is made at the point of the intrusion.

Wiring is closed circuit and is connected to door switches which are sensing devices that detect door openings and trigger the signal on the indicator panel. Key control switches can be obtained to permit authorized passage through doors Exit alarms can be installed in conjunction with the remote indicating panel. Refer to DM-13. 02 regarding the type of device best suited for the level of intrusion detection desired for a particular installation. For information on manufacturers of intrusion detection devices , contact NAVFACENGCOM Headquarters Code 04. d) Television Monitoring System. Interior closed-circuit television (cCTV) can be used to observe exits in remote or hidden locations.

A basic CCTV system consists of a camera, a television monitor, an interconnecting cable, and a source of power for operation. This basic system can be expanded to include several cameras and one or more monitors with means for manually switching from one camera to another. Where required, remote controls be implemented to aim cameras in a given direction (e,g. , pan and tilt) and to control camera focal length (e.g. , zoom, iris, and focus) . Exterior CCTv is also possible, but is more complex and costly and usually requires special lighting. 5.3 tical Codes and Standards.

Foreign, state, municipal, county, and other local building and zoning codes and ordinances should be reviewed for possible conflicts with NAVFACENGCOM and other federal project requirements While it is not mandatory that NAVFAC projects comply with these regulations, the designer is encouraged to cooperate with local officials and NAVFAC personnel to accommodate the basic intent.of the codes as much as possible. 5.4 National Codes and Standards.

Certain national codes and standards are referred to specifically in this and other NAVFAC criteria manuals , guide specifications, and other technical publications Compliance with these referenced standards when required by law”or other directive is mandatory. ‘rhefollo”ing codes and standards are among those cited. -.. . ,J Building Codes ,:,...,,.:, .,. ,,,. 5.4.1” .!,c.:.- ,.:.,( -r;,., p, a) Building Officials and Code Administrators International U ~Inc. BOCA National Buildine Code (generally used in central states) . (BOCA), b) International Conference of”‘Buildirw Officials (ICBO) . Uniform Buildine Code (UBC) (generally used’ in &&tern “states and” ~~ pacific protectorates) . .14