Print Workflow 3 If the fabric is not set, the red counter will show 9999. This shows there is a gap of about 10 mm. Values may vary depending on the condition of the belt. If the fabric is set, the red counter displays the gap between the print head and fab- ric. 4 Press the + or - of the selector to set the threshold value. The value is displayed by the green counter. The difference between the red counter and green counter is the threshold value. 5 Close the display cover. 110 No. Name Description 1 Green counter This is the setting for the threshold value. If detected value falls below this number, an error occurs and printing stops.
2 Red counter Displays the height of the fabric, measured with a laser. 3 Selector Use the selector to set the height. Press + to increase the value for the green counter, and press - to decrease the value. Recommended setting: Set a value that is 2000 less than the red counter. Setting example: If the red counter is set to 4500, set the green counter to 2500.