EPSON — EVO TRE 32

Specifications Factory facilities 37 Item Specifications Notes Electrical power See "EVO TRE 32" on page 36. Pressurized air Connector: Connect with a Φ12 mm (ext. diam.) hose Pressure: 0.6 MPa (6 bar) Flow rate: 5,000 Liter/hr Required for raising/lowering the cleaning tank, ink pressure, etc. Water Connector: 3/4 gas Pressure: 0.4 Mpa (4 bar) - 0.6 MPa (6 bar) Flow rate: Max 100 Liter/hr {6,102 in3/h} Required for belt cleaning. Wastewater Connector: Φ100 mm Connect with a Φ48 mm (ext. diam.) pipe (Applicable pipe diameter: 40 A) Required for wastewater for belt cleaning. Users are requested to dispose of wastewater according to local laws and regulations.

Waste liquid Flushing area Outer diameter of ink discharge outlet: Φ14 mm Applicable inner tube diameter: Φ12 mm Waste ink is discharged from the flushing area and cleaning station, and therefore it is neces- sary to provide a route for waste liquid in the factory's drainage system. Users are requested to dispose of waste ink according to local laws and regulations. Provide either one or two routes for waste liq- uid, depending on the usage environment. Cleaning station Outer diameter of ink discharge outlet: Φ29 mm Applicable inner tube diameter: Φ27 to 28 mm Exhaust Connector: Φ 125 mm Pipe length: 10 m Flow rate:

1,200 m3/hr {73,228,493 in3/h} (A tube diameter of Φ125 mm corresponds to a wind speed of 27.1 m/sec.) (A tube diameter of Φ200 mm corresponds to a wind speed of 10.6 m/sec.) Required for mist exhaust in the machine. If connection with factory exhaust is not pos- sible, please provide a mist exhaust fan. Network A communication speed of 100BASE-TX or more is recommended Please provide a network environment to which a PC can be connected.