Print Workflow 19 Affix the fabric that was pulled from the top of the pressure roller to the belt. 20 Close the rear protective covers. 21 Turn the pressure selection switch (black) to the right so that the fabric is affixed to the belt, without any areas where the fabric has lifted up. Move the pressure roller forward and back to affix the fabric to the belt. This completes the work on the rear. Next, perform the work on the front. 22 Press the belt feed button (forward) to feed the fabric forward. 23 Install the fabric on the winder. Feed the fabric as necessary. This completes the procedure for installing the fabric.
95 If there is enough length in the fabric edge, feed the fabric until the dryer and hold the fabric edge down with the roll core installed in advance on the take-up device or take-up unit. (If taking up, use adhesive tape.)