Atari Games Final Lap — final_lap_2.jpg

Final Lap Set-Up b. Ensure that all plug-in integrated circuits on each PCB are firmly plugged into their sockets. WARNING To avoid electrical shock, do not plug in the cabinet until it has been properly in- c. Inspect the power the insulation. cord for any cuts or dents in spected and set up for the line voltage in your area. d. Inspect the power supply. Make sure that the correct fuses are installed. Check that the harness is plugged in correctly and that the fuse block cover is mounted in place. Check that the green ground wires are connected. This cabinet should be connected to a grounded threewire outlet only.

If you have several cabinets, each one should be connected to its own separate grounded outlet. e. Inspect other major sub-assemblies, such as the video display, printed-circuit boards (PCBs), and speaker. Make sure that they are mounted se- curely and that the ground wires are connected. If you have only two-wire outlets, we recommend that you hire a licensed electrician to install grounded out- lets. Players can receive an electrical shock if the cabinet is not properly grounded.

Inspecting the Game Table 1-1 Game Specifications Characteristic Specification Power Consumption 150 V-A, 110 W RMS Temperature +5° to +50° C Humidity Not to exceed 95% relative (+37° to +122° F) WARNING Do not plug in the game until you have completed the following inspection steps. Line Voltage 102 to 132 VAC (U.S. games) Width 50 in. (127 cm.) Depth (with seats) 64 1/4 in. (163.2 cm.) Height 60 in, (152.4 cm.) Weight 625 lbs. (284 kg.) Please inspect your Final Lap game carefully to ensure that the game is complete and was delivered to you in good condition. Figure 4-1 shows the locations of the parts of the game. Table 1-1 lists space, power, and environmental requirements. 1.

Examine the exterior of the cabinet for dents, chips, or broken parts. 2. Unlock and open the lower service door. Unlock and open the coin doors. Inspect the interior of the cabinet as follows: a. Ensure that all plug-in connectors (on the cabinet harnesses) are firmly plugged in. (The connector bracket next to the EMI enclosure is for the car type selection. One of three connectors can be plugged into the connector bracket or none of them may be. For more information, see Choosing the Car Type in this chap- ter.) together. The connec- tors are keyed so they fit only in the proper orientation. A reversed edge connector can dam- age a printed-circuit board (PCB) and will void your warranty.

The seat platform is shipped separately from the game cabinet. Inspect the game cabinet and seat assembly as follows: Do not force connectors Installing the Seat Platform The seat platform must be connected to the game cabinet with two pipes and two side brackets. The parts required for this procedure are packaged with the seat and in the extra parts package. The speaker harnesses must also be connected. See Figure 1-1, Installing the Seat Platform, for an illustration. Installation is easier if you set up the seat platform to face the cabinet before you begin. The seat platform also should be at least three feet away from the game cabinet. 1.

Remove the two seat platform panels below and behind the seats by taking out the eight Phillipshead screws that hold each panel on the seat platform.