Atari Games Final Lap — final_lap_2.jpg

Maintenance Final Lap * Tighten the two screws on the spring catch. * Lubricate the spring with Nyogel, leum grease. a heavy petro- * Lubricate the bronze bearing at the end of the steering wheel case. 1. Open the control panel. Tightening the Screws on the Stop Brackets 1. When the control panel is open, 2. Use a 3/16-inch Allen head wrench to tighten the screw on the end of the steering shaft. See Figure 3-2. Make sure it is torqued to 95 inch-pounds. the two stop brackets face the seats. See Figure 3-2. 2. Make Tightening the Socket-Head Screw on the End of the Steering Shaft sure the four Phillips-head screws are tight.

Tightening the Screws on the Spring Catch The stop catch is mounted directly on the steering shaft, over the spring. The screws secure the spring catch, which keeps the spring in tension. See Figure They should be torqued to 28 inch-pounds. 3. If a screw has fallen out, replace it immediately. 3-2. 1. Open the control panel. Socket-Head Screw 24 Tooth Spur Gear Shaft Washer 36 Tooth Spur Gear Oil Retaining Ring Bronze Bearing Steel Spacer Left Stop Bracket — sJ Potentiometer Torsion Spring Hex Nut Catch Right Stop Bracket Steering Wheel Steering Wheel Cap Figure 3-2 Steering Wheel Assembly 3-3