Final Lap Maintenance 2. Turn the steering wheel so you can reach both the socket-head screws and the nuts on the spring 3. Take off the washer. 4. Put two drops of light oil on the top surface and inner surface of the bronze bearing. catch. 3, Use a 5/64-inch Allen head wrench for socket head screw and an 11/32-inch hex driver for nuts, 5. Reassemble the steering wheel shaft. and Lubricating the Gear Shift torque the screws to 28 inch-pounds. Lubricating the Spring 1. Open the control panel. Use Nyogel grease to lubricate the spring. 2. Put grease on the shifter plate. See Figure 3-1. Lubricating the Bearing 3. Check the round rubber bumpers 1.
Take off the gear on the steering wheel shaft by removing the socket-head screw on the end Maintaining the Pedals of the shaft. See Figure 3-2. 1. Take the pedal assembly out of the game. See Figure 3-3. Use a 5/32-inch Allen head wrench to re- 2. Pry off the retaining ring. Cover the ring with a cloth while you pry it, so it doesn’t fly off. Button Head Screw Locknut Spur Gear Rubber Bumper Modified Spur Gear Button Head Screw Gas Pedal Spring Set Screw Shoulder Screw Spring Bar Potentiometer Countersunk Screw Gas Pedal Figure 3-3 Pedal Assembly 3-4 for wear. If a bumper is worn, turn it.