Final Lap move Maintenance the four screws on the cover plate. These hold the assembly onto the cabinet. Pull the assem- bly out towards the seat. . Make sure the screw on the gear on each pedal is tight. If it is not, tighten it. See Figure 3-3. . Put two drops of oil on the shaft of the shoulder screw, 3. Replace the pedal assembly. Cleaning the Coin Mechanism Use a soft-bristled brush to remove loose dust or foreign material from the coin mechanism. A toothbrush can be used to remove any stubborn build-up of residue in the coin path. After cleaning the coin mechanism, blow out all of the dust with compressed air. Perform the following procedure to clean the components inside the cabinet.
1. Open the rear access panel and display service panel. 2, Discharge the high voltage WARNING Turn off the game power, but do not unplug the power cord before cleaning inside the cabinet. The power cord pro vides a ground path for stray static voltages that can be present on the cleaning tools. the cathode-ray age to ground when power is removed. However, to make follows: certain, always discharge the display as a. Attach one end of a large, well-insulated, 18- gauge jumper wire to ground. b. Momentarily touch the free end of the grounded jumper to the CRT anode by sliding it under the anode cap. c. Wait two minutes and repeat part b.
Cleaning the Interior Components from tube (CRT) before proceeding. The display assembly contains a circuit for discharging the high volt- CAUTION Be extremely careful when cleaning the electrical components inside the cabinet. Avoid touching the electrical components with any solid object other than the soft bristles of the vacuum attachment or paint brush. . Use a vacuum cleaner with a soft long-bristled brush attachment or use a soft-bristled paint brush to remove loose dirt and dust accumulated on the inside of the cabinet. Be sure to clean the electrical components thoroughly semblies, display, etc.). (power supplies, PCB as-