Maintenance Final Lap Repairs Repairs include the removal, disassembly, re-assembly, and replacement of game components. 12. If you move the gear on the potentiometer shaft: The following a. Make procedures are provided for components that may require repairs. Replacing Steering Wheel a 1/4-inch Allen wrench to remove the. steering shaft and is the same height as the oth- ef gear. c. Check screw screws in the center of the wheel. 13. 4, Install the new steering wheel. Replace the screws and the center cover. Replacing the Steering Wheel Spring to be sure the potentiometer gear set is on flat part of potentiometer shaft and lines up with the center terminal on the potentiometer.
Tighten the set screw. the three 3. Remove the steering wheel. shaft b. Now put on the gear on the potentiometer. Make sure it completely meshes with the gear on If you want to replace the steering wheel, but not the inside controls, follow this procedure. You do not need to open the control panel. 1. Pry the center cover off of the steering wheel. 2. Use sure flat part of the potentiometer lines up with the center terminal on the potentiometer. When the gears mesh and are the same height, tighten the set screw on the gear on the potentio- meter shaft. 14. Reassemble the steering shaft.
Replace the Steering Wheel Potentiometer If the steering wheel does not snap back to the center when you turn it, replace the steering wheel spring. If the steering wheel is working correctly, but the player’s car on the video See Figure 3-2. 1. Open the control panel. 2. Loosen the screw on the end of the steering shaft. Take off small gear at the end of the steering shaft. display is not responding, you may need to replace the potentiometer. First check to see if the steering wheel fails the self-test. If it does, first check the mechanical parts of the steering wheel. If these are working properly, you may need to re- 3. Pry off the retaining ring.
Be careful when you pry it off, since it will fly off the shaft. place the potentiometer. 1. Open the control panel. See Figure 3-2. 4. Remove the large washer below the retaining ring. 2. Take off large gear on the potentiometer shaft. Use 5. Take off both stop brackets by removing the Phillips-head screws holding the brackets on the case. a 5/64-inch Allen head wrench to loosen the gear set screw. 3. Use a 1/2-inch hex driver to remove the lock nut and washer that hold the potentiometer on the case. 4. Push the potentiometer out towards steering wheel. 6. Take off the catch on the spring. Use 9/64-inch Allen wrench on the socket-head screws and an 11/32-inch hex driver on the Nyloc nuts.
Remove the screws, nuts, spacers, and catch. Remove the wiring harness. 7. Pull the shaft out towards the steering wheel. 5. 8. Put on a new spring. The spring must be well lubricated with Nyogel grease. 6. 9. Replace the washer and retaining ring. 7. 11. Replace the gear and the socket-head screw on the end of the shaft. The steering shaft gear must mesh 8. Tighten the potentiometer lock nut to 30 inchpounds. Now put on the gear on the potentiometer. Make sure it completely meshes with the gear on the steering shaft and is the same height as the other gear.
with the gear on the potentiometer shaft and must 3-6 Make sure flat part of the potentiometer shaft lines up with the center terminal on the potentiometer. 10. Replace the catch. Make sure it holds the spring in tension. be the same height. If not, move the gear on the potentiometer shaft. Replace the potentiometer. Put the key into the hole in the case. 9. Check to be sure the potentiometer gear set screw