Atari Games Final Lap — final_lap_2.jpg

Final Lap is on flat part of potentiometer shaft and lines up with the center terminal on the potentiometer. Tighten the set screw. 10. Install the wiring harness. The red wire is on the left, the brown wire is in the middle, and the black wire is on the right. Replacing the Gear Shift 1. Open the control panel. 2. Disconnect the wiring harness from the gear shift. 3, With a 3/8-inch nut driver, remove the four nuts holding the gear shift on the panel. 4, Remove the gear shift through the front of the control panel. Maintenance Replacing the Stops on the Foot Pedal If one of the pedals sounds as if it is hitting metal when it is pressed or released, replace the rubber stops on the pedal. 1.

Take the pedal assembly out of the game. Use a 5/32-inch Allen head wrench to remove the four screws on the cover plate. These hold the assembly onto the cabinet. Pull the assembly out towards the seat. 2. potentiometers. 3. Remove foot pedal plate by loosening the two countersunk socket-head screws that hold the pedal plate on the pedal arm. Use a 5/32-inch Allen head wrench. See Figure 3-3. 4, Remove the four screws around the pedal that hold it on the cover plate. Loosen the nuts with a 7/16- 5. Replace the gear shift. Assemble in reverse order. Replacing the Microswitch on the Gear Shift inch wrench. 1. Open the control panel. 2. Disconnect the wires to the switch on the gear shift. 5. :

Loosen the spring bar that holds the spring in ten- sion on the bottom rear of the pedal. Use a 3/16 See Figure 3-1. Allen wrench on the socket-head screw and a 7/16 wrench on the nut. Remove the screw. 3. Remove the screws that hold the switch on the gear shift. 4. Remove the switch. Remove the wiring harness from the gas and brake 6. Remove the two buttonhead screws on the front rubber stop that hold the stop on the metal plate. 5. Replace in reverse order. Use an 1/8-inch Allen wrench on the screws and a 3/8-inch wrench on the nuts. Remove the rubber stop and replace. 7. Replace the screws and nuts holding the rubber stop. 8.

To replace the back horizontal stop, first remove the potentiometer and gear. 9. Loosen the lock nut on the potentiometer with a 1/2-inch flat wrench. 10. Loosen the set screw on the gear on the potentiometer. 11. Remove the gear from the potentiometer shaft. 12. Remove the potentiometer. 13. Remove the two button-head screws that hold the stop on the horizontal metal plate. Use an 1/8-inch Allen wrench on the screws and a 3/8-inch wrench on the nuts. Remove the rubber stop and replace. 14. Replace the screws and nuts holding the rubber stops. 15, Replace the potentiometer. Make sure the potentiometer key is in the hole in the case, so the flat side of the potentiometer shaft faces up. 16.

Put on the lock nut. Tighten it part way. 17, Put the gear on the shaft. Make sure it completely —