Atari Games Final Lap — final_lap_2.jpg

Final Lap Maintenance 2. Position the display so that the four holes in the video display mounting brackets align with the four holes in the video display shelf. pear defective due to leakage on a PCB. To make sure a device is defective, ground any static voltages as de- 3. Install the four hex head screws through the mount- the PCB with flux remover or an eraser. For discrete FETs, clean thoroughly between the gate, drain, and ing brackets and into the video display shelf. 4, With the hex-head screws loosely installed, push the video display forward to meet the bezel. 5. Use a 3/8-inch nut driver to tighten the bolts. Be sure that the display is centered horizontally.

scribed in the paragraph above. Clean both sides of source leads. Then test the device. If you are replacing a static sensitive device, new static-sensitive devices may be packaged in conductive foam or may have a protective shorting wire attached to the pins. Remove the conductive foam just prior to inserting the device into its socket or soldering it to a PCB. Remove the shorting wire only after the device is 6. Connect the display harnesses to the display. Removing the Game PCBs inserted into its socket dered in place. Perform the following procedure to remove or replace or after all the leads are sol- the Final Lap Video, CPU or EMI PCBs. Removing the Speakers 1. Turn the game power off.

Perform the following procedure to remove the speak- 2. Open and remove the lower service door. 3. The vertical green PC board is the EMI board. It is connected to the CPU PCB and the video PCB inside the EMI enclosure. The EMI enclosure is the perforated metal box. 4. Remove the 6 screws that hold the EMI PC board on the enclosure. 5. Take off the edge connectors on the EMI PC board. 6. Carefully pull the EMI PC board out, along with the CPU and the video PCBs. 7. Replace the Game PCBs in the reverse order of removal. Replacing Static-Sensitive Devices devices on the game PCBs.

These can be microprocessors, field-effect transistors (FET), complementary metal-oxide semiconductors (CMOS), and other large-scale integration (LSI devices that use metal-oxide semicon- ductor (MOS) technology. Static charge that has built up in your body can cause device to fail. Leakage from an im- properly grounded soldering iron can also cause a static-sensitive device to fail. Before you handle a static-sensitive device or a PCB with such devices attached to it, ground any static voltage that may have accumulated in your body by touching an object that has been earth grounded.

A bare wire wrapped around your wrist and attached to an earth ground is effective when working extensively with static-sensitive devices. When you solder a static-sensitive device, use a soldering iron with a properly grounded three-wire cord. Before you replace a static-sensitive device, make sure it is actually defective. A static-sensitive device can ap- 3-10 2. Remove the red fiberglass seat back. Remove all the screws from the sides of the seat, plus those on and behind the metal plate on the back of the headrest. You will need a Phillips screwdriver, an Apex A-2 square drive wrench, and an 1/8-inch Allen head wrench. CAUTION Do not touch the speaker cone when han- dling the speaker.

The cone material is fragile and can be easily damaged. 3. Disconnect the wires to the speaker. Be careful when you are working with static-sensitive a Static-sensitive ers. (See Figure 3-5.) 1. Turn the game power off. 4. Loosen the four nuts that hold the speaker on the speaker bracket. Remove the speaker. 5. Replace the speaker in the reverse order of removal, Be sure that you hook up the wires correctly. The signal wire on the speaker should be attached to the speaker tab marked with color, a “+” sign, or a round dot. (The signal wire is shown on the game wiring diagram; refer to the Schematic Package included with the game.) 6. Replace the seat back.