Main Drive Assembly 1 Remove the Back Cover from the 2000-sheet Input Tray (see figure 6-63). Figure 6-66 2000-sheet Input Tray Main Drive Assembly 2 Locate the cable that runs from the Main Drive Assembly on the 2000-sheet Input Tray to the unit’s Controller PCA. Disconnect the cable from the J206 connector on the Controller PCA (figure 6-66, callout 1). 3 Release the cable from the 2 cable clips that hold the cable to the chassis (figure 6-66, callout 2). 4 Remove the 2 screws that connect the Main Drive Assembly to the chassis: 1 screw on top of the Main Drive Assembly and 1 screw on the bottom (figure 6-66, callout 3). 5 Pull the Main Drive Assembly away from the chassis.
6 Inspect the Paper Deck Drive Bushing on the Main Drive Assembly. If the bushing is damaged, it can be replaced without replacing the whole drive assembly. Note Reassembly notes are on the next page. C4085-91087 2000-sheet Input Tray Removal and Replacement 237