Basic software procedures Using an UEFI BIOS К Enter the BIOS setup menu. К Select the Advanced menu. The addresses are displayed at the Advanced menu main page. I Only network controllers supporting the Command Line Protocol (CLP) will be displayed. Using the vendor tools in a Legacy BIOS To get the WWN address use the vendor tools, see "Using the vendor tools in a Legacy BIOS" on page 101 . 5.2.16.3 Looking for the GUID address of an infiniband or Omni-Path controller There are several possible locations where these addresses can be found. К Inform the customer about the new or changed GUID address. Checking the label К If available, check the label on the controller.
Beside the part number, you may find the GUID address. Using the vendor tools in a Legacy BIOS To get the GUID address use the vendor tools, see "Using the vendor tools in a Legacy BIOS" on page 101 . 5.2.16.4 Looking for SAS addresses of SAS controllers for external devices There are several possible locations where these addresses can be found. К Inform the customer about the new SAS address. The customer need the new SAS address, especially when the server is connected to a Fujitsu Storage ETERNUS system. Using the vendor tools in a Legacy BIOS To get the SAS address use the vendor tools, see "Using the vendor tools in a Legacy BIOS" on page 101 .
102 Upgrade and Maintenance Manual RX2530 M4