Basic software procedures К In the Ethernet Ports group, you will find detailed information on each network controller in the managed PRIMERGY server, including its MAC address. I This information is only available with the iRMC S5 or above. Only network controllers supporting the Command Line Protocol (CLP) will be displayed. I For add-in cards the vendors provide documentation and tools, offered on the Fujitsu support web pages: http://ts.fujitsu.com/support/ Select the server, select Downloads - More Details - Driver . Some vendors bundle the documentation together with the driver package. Using the vendor tools in a Legacy BIOS К Enter the BIOS setup menu. К Select the Advanced menu.
К Under CSM Configuration set the Boot option filter to Legacy only. К Save your changes and exit the BIOS. К Reboot your system. Your system will now start with Legacy Boot. When starting your system with Legacy Boot, the different vendor tools will be displayed on the screen. К Press the required key to enter into the vendor tool. К Step forward to get access to the address of interest. 5.2.16.2 Looking for the WWN address of a fibre channel controller There are several possible locations where these addresses can be found. К Inform the customer about the new or changed WWN address. Checking the label К If available, check the label on the controller.
Beside the part number, you may find the WWN address. RX2530 M4 Upgrade and Maintenance Manual 101