Basic software procedures 5.2.16 Looking for MAC/WWN/GUID and SAS addresses The customer needs to know the new address of the controller: When replacing the system board with an onboard LAN controller When adding or replacing a network controller When adding or replacing a SAS controller Different controllers send different addresses: LAN controller: MAC (Media Access Control) address Fibre channel controller: WWN (World Wide Name) address Infiniband/Omni-Path controller: GUID (Globally Unique IDentifier) address SAS controller: SAS (Serial Attached SCSI) address 5.2.16.1 Looking for the MAC address of a LAN controller There are several possible locations where these addresses can be found.
К Inform the customer about the new or changed MAC address. Checking the label К If available, check the label on the controller. Beside the part number, you may find the MAC address. Using an UEFI BIOS К Enter the BIOS setup menu. К Select the Advanced menu. The addresses are displayed at the Advanced menu main page. I Only network controllers supporting the Command Line Protocol (CLP) will be displayed. LAN controller provide the MAC addresses independent on Legacy Boot or UEFI Boot. Using the iRMC web interface К Log into the ServerView iRMC web interface. К Open the System menu. К Open the Network page. 100 Upgrade and Maintenance Manual RX2530 M4