Power supply unit (PSU) 6.3.1.3 Installing an FJBU Figure 45: Installing an FJBU К Push the FJBU into its bay as far as it will go until the locking latch snaps in place. V CAUTION! Ensure that the FJBU properly engages in its bay and is locked in position in order to prevent it from sliding out of the chassis during transportation. 6.3.1.4 Concluding steps К No steps needed. I To execute auto shutdown after power fail, you should install the FJBU management software. How to install and configure the FJBU management software, see the “Fujitsu Battery Unit" user guide. 6.3.2 Removing the FJBU Customer Replaceable Unit (CRU) Hardware: 5 minutes Tools:
tool-less Note for servers using CMA (Cable Management Arm) Regarding of removing the FJBU, additional tasks are needed, due to an interference between CMA stopper and the FJBU. 124 Upgrade and Maintenance Manual RX2530 M4