fujitsu RX2530 M4 — FUJITSU Server PRIMERGY RX2530 M4

Basic hardware procedures 4.4.2 Removing the server from the rack I In most cases maintenance tasks can be performed while the server is extended from the rack. However, depending on accessibility or security guidelines, it may make sense to completely remove the server from the rack cabinet for maintenance purposes. V CAUTION! At least two people are needed to lift the server out of the rack cabinet. (For Japan, please refer to " 安全上のご注意 ".) For configurations below 32 kg: At least two people are needed to lift the server out of the rack cabinet. For configurations below 55 kg: At least three people are needed to lift the server out of the rack cabinet. For configurations above 55 kg:

At least four people are needed to lift the server out of the rack cabinet. Additionally, a lifter is required in the following cases: The server weighs more than 50 kg. The server weighs more than 21 kg and is installed above the height of 25 U. When using a lifter, this removal procedure needs to be carried out by maintenance personnel. 54 Upgrade and Maintenance Manual RX2530 M4