Basic hardware procedures 4.6 Connecting the power cord 4.6.1 Connecting the power cord (AC PSU) V CAUTION! The AC PSU adjusts automatically to any power voltage in the range from 100 V - 240 V (AC PSU Platinum) or 200 V - 240 V (AC PSU Titanium). You may only operate the server if its rated voltage range corresponds to the local mains voltage. К If applicable, connect the mains plugs to power outlets of the rack socket strip. I To provide true phase redundancy, the second PSU should be connected to a different AC power source from the other PSU. If one AC power source should fail, the server will still continue to run. К Connect the power cords to the PSUs.
К Ensure that the status indicator on the PSU is lit green, see section "Indicators on PSUs (hot-plug PSUs)" on page 431 . Figure 15: Locking the cable clamp of a PSU К Pull the cable clamp up (1). К Thread the power cord through the cable clamp (2). К Press the cable clamp down until it engages to secure the cable (3). I It will take about 60 seconds until the server can be powered on. RX2530 M4 Upgrade and Maintenance Manual 63