Basic software procedures К Save your changes and exit the BIOS. I Up to two Option ROMs can be activated in the BIOS at a time. For more information on how to access the BIOS and modify settings, see the corresponding BIOS Setup Utility reference manual. When the enabled expansion card is initialized during the POST phase of the boot sequence, a key combination is displayed temporarily to enter the firmware of the expansion card. К Press the displayed key combination. К Modify the expansion card firmware options as desired. К Save your changes and exit the firmware. I The option ROM of the expansion card can now be disabled in the BIOS. Exception:
If the expansion card controls a permanent boot device, the Option ROM of the expansion card has to remain enabled. 5.2.5 Reconfiguring the backup software solution I This task only applies to Japan. Depending on the backup software solution, it may be necessary to disable or delete the backup drive from the backup software drive list and reconfigure backup jobs after completing the maintenance task. I More information on suitable backup software solutions and related documentation is available from the Fujitsu web pages.
Disabling backup drives Re-enabling backup drives If a backup drive has been disabled or deleted from the backup software drive list as described in section "Verifying and configuring the backup software solution" on page 80 , it has to be re-enabled to complete the maintenance task. К Re-enable backup drives and revise backup software settings and cronjobs. I More information on suitable backup software solutions and related documentation is available from the Fujitsu web pages. RX2530 M4 Upgrade and Maintenance Manual 87