fujitsu RX2530 M4 — FUJITSU Server PRIMERGY RX2530 M4

Basic software procedures 5.2.13 Updating the NIC configuration file in a Linux and VMware environment In order to prevent errors caused by changing network device names ( eth ), it is recommended to store the MAC address (hardware address) of a network interface card in the related NIC configuration file of the Linux/VMware OS. When replacing a network controller or the system board with onboard LAN controllers in a server running Linux/VMware OS, the MAC address will change but not automatically be updated in the definition file. In order to prevent communication problems, it is necessary to update the changed MAC address stored in the related ifcfg-eth definition file.

To update the MAC address, proceed as follows: I Procedures may differ depending on your Linux/VMware OS or the definition file on the client system. Use the following information as reference. Ask the system administrator to change the definition file. К After replacing a network controller or the system board, switch on and boot the server as described in section "Switching on the server" on page 66 . kudzu , the hardware configuration tool for Red Hat Linux, will launch at boot and detect the new and/or changed hardware on your system. I kudzu may not launch at boot depending on the client’s environment. К Select Keep Configuration and Ignore to complete the boot process.

К Use the vi text editor to specify the MAC address in the HWADDR section of the ifcfg-eth file: I The MAC address can be found on the type label attached to the system board or network controller. Example: In order to modify the definition file for network controller 1, enter the following command: # vi /etc/sysconfig/network-scripts/ifcfg-eth1 In vi , specify the new MAC address as follows: HWADDR=xx:xx:xx:xx:xx:xx К Save and close the definition file. RX2530 M4 Upgrade and Maintenance Manual 97