Basic software procedures К For the changes to take effect, you need to reboot the network by entering the following command: # service network restart I If the system board or network controller offers multiple LAN ports, it is necessary to update the remaining ifcfg-eth definition files accordingly. К Update the NIC configuration file to reflect the new card sequence and MAC address. 5.2.14 Resuming BitLocker functionality If BitLocker Drive Encryption has been suspended for maintenance purposes (see section "Suspending BitLocker functionality" on page 77 ), it has to be re- enabled to complete the service task.
I If BitLocker Drive Encryption has been suspended prior to replacing components you won't be asked for a recovery key when rebooting the server after the maintenance task. However, if BitLocker functionality has not been suspended, Windows will enter recovery mode and ask you to input recovery key for further booting. К In this case, ask the system administrator to enter the recovery key in order to boot the operating system. К Ask the system administrator to enable the previously suspended BitLocker- protection on the system volume, using the BitLocker Drive Encryption control panel item:
К Click Start - Control Panel - System and Security - BitLocker Drive Encryption to open the BitLocker Drive Encryption. К Select the system volume, and click Resume Protection . I For more information on how to resume BitLocker drive encryption, see the Microsoft TechNet library at http://technet.microsoft.com/library/cc731549.aspx. For more information, see the Fujitsu web pages. 98 Upgrade and Maintenance Manual RX2530 M4