Downloaded from https://www.everyspec.com AMCP 706-210 repositioned-by turning, and detents can he ith- ogive. An angle of 75' wil! serve as a, first ap- drawn against spring rproxinmation. '1'he final angle depends on the ratio of setback to con trifugalforces. 10-3.1 SLIDERS A retainer speing can.satisfy requirement (2) as well as the-rough handlintgrequiremens. It re- Sliders form a conwenient way to hold the mains to adjust the spring constant and'the posi- -detonator out-of-line.
Here tie- designer is in- tion of slider mass cente" with respect to the terested -in -the time interval, after firing the spin axis, Fortunately, requirement (3) is oh- projectile, during which the fuze is safe or the tained with the same calculations. slider ha- not moved, lie calculates this froin Siice the slider will generally continue to estimated dimensions of the slider. The time move once it starts (tile spring;force is balanced interval rcquirement may be stated in this fash- by the increasing centrifugal force and the ki- ion:
(,1) the time interval for sliders must not netic friction coefficient is less than the static begu-until after the projectile leaves the gun be- onc), the designer needs to know the conditions cause the fuze must be bore safe (the separate under which the slider will move. Set x x .e in time delay, required-while the fuze is in the bore, Eq. 6-29 and reduce it to is usually achieved by setback), (2) the fuze must tdf - -kx - Wia! (sined ,i cosd) not arm below a certain spin velocity (the con- (10-8) trifugal field is too weak to cause afining),,and f, f)2 r. (cos - Itsinq)I (3)'tie fuze mustdefintely arm abovea certain- spin velocity.
These coicepts are discussed-more For requirement (1) 0 for all possible fully in par. 9-2.2. values-of (o, for requirement (2),Ј 0fora'-- 0 'If lte- slider is, placedat air angle less than 90 0 and where w is 4the 'l)wer spin specification, and' -to the spin axis, setback-forces will have a corn- for requirement (3)° x" > 0- where a' is the creep ponent that opposes radial outward motion of deceleration and w is the upper spin spec~fica- the slider. This provision .an satisfy. requirement tion. ,(1).
For a nose fuze, a convenient angle is that As in example, Suppose it is desired to find' which makes,:'the slder perpendicular to the the~ glarspin vel6city necessary to arm a fuze ' RUEASE L{vE R *EEr'NOr.B SH4 1~~FQW ASSSEMOI i~~~ At O hT -4b- •r~3 qqu, - -7 § - -- )J Figure 10-3. Leat'Arming Mdechanism of Fuze, Md532 i0.4