Downloaded from https://www.everyspec.com AMCP 706-210 operation. One way of providing heat is to sur- Capacitors are also useful if they are con- round the individual cells with a pyrotechnic nected in parallel with a battery of high voltage material that is ignited by a percussion primer, but of low current. Such a battery can supply The activation time (the time for the electrolyte electrical energy over a period of time to charge to melt) varies from about % sec to about 8 sec the capacitor to the open circuit voltage of the depending on battery size; the smaller the bat- battery and maintain that charge if its output tery, the faster the activation time.
Thermal is greater than the leakage current. The capacitor batteries can be designed for a variety of dimen- can then discharge this stored energy at the de- sions and outputs. Their active life is about 10 sired time and rate. The electrical energy H, is min. They are inherently rugged, withstanding all given by required shock and vibration tests, and have a shelf life of approximately 15 yr. 2 ( H/e G ' (E, - E 2 . .) joule (3-3) 3-4.3.4 Capacitors Capacitors can be used as convenient sources where the E's are in volts and C in farads. when an electric pulse of short duration is re- quired. Advantages are lightness, economy, and 3-4.4 TIMING CIRCUITS stability.
Capacitors may either be precharged from an external power source or from a self- Electrical time fuzes and electrical functioning contained source such as a battery or a piezo- delays are achieved by the same general system. electric transducer. Assume that the voltage to Since RC timing circuits are used more common- which the capacitor is charged, the minimum, ly in the arming process, they are discussed in voltage required to initiate the detonator, and par.7-3. the load resistance are known.
Then the time interval t during which a given capacitor can op- 3-4.5 INITIATION OF THE FIRST EXPLOSIVE erate as a power supply, i.e., retain a usable ELEMENT charge, is given by While the details of electrical explosive ele- E ment, are discussed in par. 4-3.1.4, consideration t R L C 1n -L, sec (3-2) must be given to their initiation. In mechanical E initiaion, fuze functioning and initiation of the where first element in the explosive train are directly related.
Electric initiators, however, respond to RL = total leakage resistance of the sys- an electrical signal that may be produced far tem, including the capacitor, ohm from the initiator so that the electric pulse may be affected by the transmission line. Also, the C = capacitance of the capacitor, farad resistance of the initiator can affect size and duration of this transmitted pulse from the E = voltage at which capacitor is power source. Different initiators have resist- charged, volt ances which vary from a few ohms, or even to megohms.
Energy requirements vary from a = voltage required to initiate the det- few hundred to several thousand ergs although, onator at the capacitance of the for certain initiators, the initiating energy is not the most satisfactory or only parameter to capacitor, volt consider. The designer, after deciding upon a suitable The dielectric materials with the least leak e power source, must first ascertain what part of for use in fuze capacitors are Mylar*, polysty- its original pulse can be passed on to the initiator rene, and mica. and then he must choose an initiator wh'ch will detonate when the minimum available pulse is *Regi, tered trade name, E. 1.duPont de Nemours & Co., applied.
This is often a difficult problem be- Inc., for polythylene glycol ter,,phthala.te. cause the parameters of the initiator have not 3.9