Downloaded from https://www.everyspec.com AMCP 70&-210 CHAPTER 4 THE EXPLOSIVE TRAIN 4-1 GENERAL velocity of sound through the undisturbed mate- rial. When used in its normal manner, low explo- The explosive train is an important part of the sive burns or deflagrates rather than detonates. fuze system in that it provides transistion of a The burning rate depends upon such characteris- relatively feeble stimulus into tie desired explo- tics as the degree of confinement, area of burn- sive output of the main charge. An explosive ing surf,-ce, and composition.
In many instances, train is an assembly of explosive elements ar- low explosives are fuels mixed with suitable oxi- ranged in order of decreasing sensitivity. While dants in order to obtain the proper burning both high and low explosive trains exist, we are action. concerned mainly with the former in this As shown in Fig. 4-1, burning starts at the chapter. point of initiation 0 and travels along the col- The reader is urged to study the handbook, umn of explosive as indicated'. The products Exph~s i,,e Trains ', if his interest is in the design travel in every direction away from the burning or development of explosive trains. This refer- surface.
As a result, pressure is built up within ence contains far more detail and many more the space of confinement. The velocity of propa- references on the subject than can be included gation increases with pressure until it becomes in the scope of this handbook. constant. Low explosives are divided into two groups:
4-2 EXPLOSIVE MATERIALS (1) gas-producing low explosives which include propellants, certain primer mixtures, igniter mix- Explosive materials used in ammunition are tures, black powder, photoflash powders, and substances or mixtures of substances which may certain delay compositions; and (2) non-gas-pro- be made to undergo a rapid chemical change, ducing low explosives including the gasless type without an outside supply of oxygen, with the delay compositions. liberation of large quantities of energy generally accompanied by the evolution of hot gases. Cer- COLUMN OF LOW EXPLOSIVE tain mixtuzes of fuels and oxidizers can be made 0l to explode and these are considered to be explo- RI sives.
However, a substance such as a fuel which FLAME FRONT- requires an outside source of oxidizer, or an oxi- dizer which requires an outside source of fuel to I -- explode, is not considered an explosive. In gen- 1W eral, explosives can be subdivided into two classes, low explosives and high explosives ac- cording to their rate of reaction in normal STABLE BURNING RATE usage. Nearly all types of explosives are represented in fuzes. Each one has its peculiarities and ef- 0 STANCE ALONG COLUMN fects. Some materials are described in order to provide a basis for comparison. Since this is a IN UNDISTURO MEDIUM complex field, only the essential ideas have been introduced for use in later chapters.
Figure 4-I. Burn i.,g Low Explosive 4-2.1 LOW EXPLOSIVES 4-2.2 HIGH EXPLOSIVES An explosive is classified as a low explosive if the rate of advance of the chemical reaction An explosive is classified as a high explosive if zone into the unreacted explosive is less than the the rate of advance of the chemical reaction zone 4-1 I|