Downloaded from https://www.everyspec.com AMCP 70".10 BRIcwgRE air shock, the hangfire, namely the time lapse be- PLUG .. SLEEVE tween supply of mechanical energy to the primer LEADS output; and flame duration. Each of these meas- -T urable quantities has been related to effective- o01 ness in one or another application by experi. ment, theory, or intuition. Howver, no general 037 quantitative relationship of value to a designaer N/ has been developed. FLASH CHARGE COMPOSITION-' As its name implies, a detonator is intended to Figure 4-6. Electric Squib, M2 induce detonation in a subsequent charge.
The two features of its output which are useful for 4-3.2 INPUT CONSIDERATIONS this purpose are the shock wave it emits and the high velocity of the fragments of its case. The When using primers and detonators, one must output effectiveness of detonators of current de- consider both input and output characteristics, signs is directly related to the quantity of the ex- The decision as to which characteristic to use is plosive which detonates, and to the vigor of often dictated to the designer by the quantity of this detonation. These quantities are somewhat input energy available. For details on fuze initia- less predictable than in most other components tion see pars. 3-3 and 3-4.
Sensitivity should be because the transitions from burning to detona- no greater than necessary in the required appli- tion and from low order to high order detona- cation. tion take place in the detonator. Output of the initiator must be considered at These transitions can require anything from a the same time as input. The system requirements hundredth of an inch to the whole length of a will usually determine the type of output detonator, depending upon such factors as load- needed: a flame, a detonation, or a mechanical ing density, composition, particle size, confine- function. While perhaps to a lesser extent in this ment, and column diameter.
However, recent de- regard, the fuze designer is also concerned with velopments in lead azide production have re- construction features. suited in materials in which these transitions re- Information has been published on the char- quire so little explosive that the output of a acteristics of initiators that can serve as a good detonator can be predicted with a fair degree of starting point for consideration 3 'o. Functioning confidence. times as well as sensitivity are readily available The effective output of a detonator includes together with sizes, mounting methods, and con- factors of pressure, duration, and area over nections.
The exploding bridgewire initiators which the pressure acts. Clearly a simple product have been surveyed in a journal article'. Many of these quantities is inadequate as a character- explosive trains of different types exist that ization because a low pressure of either long have a proven record of performance c. duration or large extent would obviously be ineffective.
4-3.3 OUTPUT CHARACTERISTICS Detonator output is measured by means of gap or barrier tests, sand test, copper block test, The output of a primer includes hot gases, hot lead disk test, steel plate dent test, Hopkinson particles, a pressure pulse which, in some cases, bar test and in terms of the velocity of the air may be a strong shock, and thermal radiation. shock produced c. Measurable quantities which have been used to The output characteristics are achieved by characterize primer output include: the volume means of the explosives used. Primers are loaded of the gas emitted; the impulse imparted to a col- with one of a variety of priming compositions.
ume of mercury by the pressure pulse; the light Typical detonators have three charges--a priming output as measured by a photocell; the tempera- charge, an intermediate charge, and a base ture rise of a thermocouple exposed to the out- charge-although two of these can be combined. put gases and particles; the ionic conduction be- The priming charge is like that of the primer. tween a pair of probes exposed to the output; The intermediate charge is usually lead azide the pressure rise in a chamber in which the out- while the base charge can be lead azide, PETN, put is confined; the propagation velocity of the tetryl, or RDX. 4-8