U.S. Army Material Command (AMC) AMCP 706-210 — FUZES - Engineering Design Handbook AMCP 706-210 (U.S. Army) PDF Download

Downloaded from https://www.everyspec.com AMCP 706-210 4-3.4 CONSTRUCTION Fig. 4-7. Representative delays covering various time ranges have been compiled in a compen- Initiators usually consist of simple cylindrical diumin. metal cups into which explosives ate pressed and Explosives for delay elements may be grouped various inert parts inserted. MIL-STD-320 de. into two categories: gs-producing delay mix- scribes design practices and specifies the standard tures and "gasless" delay mixtures. (See pars. 6-5 dimensions, tolerances, finishes, and materials and 6-6 for mechanical means of achieving delay for initiator cups. In general, all initiator designs and par.

7-3 for electrical methods.) snould conform to this Standard. However, it is not the intent of the Standard to inhibit the de- velopment of new concepts so that an occasional departure from the standard may be necessary for special circumstances. PRIMER OLDER Initiators are loaded by pressing powdered ex- plosive into the cup at between 10,000 and 20,000 psi. Whlo the length of an explosive BAFFLE charge is greater than its diameter, the usual practice is to load it in increments not over one diameter long. After loading, the cup is closed 0.173 in with a sealing disk and crimped.

In addition to DELAY ODER the explosive, electric initiators contain a plug assembly consisting of the plg, electrodes, and COLUMN bridge. ELEMENT RELAY, 4-4 OTHER EXPLOSIVE COMPONENTS M6 4-4.1 DELAY ELEMENTS BODY Delay elements are incorporated into an ex- Figure 4-7. Delay Element, M9 plosive train to enhance target damage, by allow- ing the missile to penetrate before exploding, or 4.4.1.1 Gas-producing Delay Mixtures to control the timing of sequential operations. When the explosive train provides a time lag, Black powder has long been employed as a de- the component creating this lag is called a delay lay material. Formed ir.nto compressed pellets, element.

The delay must, of course, be so incor- columns, or ring segments, it has been used to porated in the fuze that it will not be damaged olztain delay times from several hundred milli- during impact with the target. This feature is seconds to one minute. Black powder is easily most easily achieved by placing the fuze in the loaded and ignited. It is readily available in a base of the missile. If this is not possible, the variety of granulations and quality.

However, delay must be buried deep in the fuze cavity in since burning black powder produces consider- the event that the forward portion of the fuze is able quantities of heat and gas, vents or gas col- stripped from the missile on target impact. lecting chambers must be incorporated into such Generally, delay columns burn like a cigarette, delay systems. Black powder is affected by load- i.e., they are ignited at one end and burn linearly. ing pressure, atmospheric pressure, moisture, and Delays may be ignited by v suitable primer. Igni- confinement.

It has largely been supplanted by tion should occur with as little disruption of other delay compositions, particularly in more the delay material as possible because a violent recent designs. ignition, can disrupt or even bypass the delay col- umn. For this reason, baffles, special primer as- 4-4.1.2 "Gasles" Delay Mixtures semblies, and expansion chambers are sometimes included in a delay element. A typical arrange- Since pressure of the evolved gas affects the ment is that of Delay Element, M9, shown in performance of delays, efforts have been made 4-9 Ii