Downloaded from https://www.everyspec.com AMCP 706-210 to produce "Palen" delay mixtures' ,2. "Gas- 4-4.3 LEADS les" mixtures are superior to other types, par. ticulary where long delay times are needed or The purpose of a lead (rhymes with feed) is to where space is limited and escape of hot gases transmit the detonation wave from detonator to cannot be tolerated. In general, "gasless" delays booster. Leads are less sensitive to initiation than are intimate pyrowchnic mixtures of an oxidant either detonators or relays and are arranged ac- and a metallic fuel carefully selected to yield a cordingly in the explosive train. minimum volume of gaseous reaction products.
Leads may be of the flanged type or of the Delays that are sealed or protected from the closed type. Flanged cups are open on the atmosphere produce more consistent times and flanged end while closed cups have a closing disk have better surveillance characteristics. Hence, similar to that of the stab or flash detonator there is a trend toward totally sealed delay shown in Fig. 4-4(A) and (D). Flanged cups are systems. pressed into place whereas closed leads are held by staking. The choice as to type is based on 44.2 RELAYS considerations for handling and safety.
For ex- ample, the flanged type lead, having exposed A relay is a small explosive component used explosive on the flanged or output end would to pick up a weak explosive stimulus, augment be undesirable in designs where the lead pro- it, and transmit the amplified impulse to the trudes from the base or where dusting or flaking next component in the explosive train. Nearly of the explosive charge could interfere with the all relays ate loaded with lead azide, a pi nary operation of the fuze mechanism. explosive.
The diameter of a relay is generally The input end, the solid end of the cup or the the same as that of the preceding and the follow- closing disk, receives the shock wave from the ing component but it is often thin. Relay cups detonator. This wall thickness is therefore im. now used are made of aluminum. portant. In practice, the wall is generally 0.005 Relays are commonly used to "pick up" the to 0.010 in. thick. explosion from a delay element or a black pow- Loading pressures for leads range from about der delay train. They are sometimes used to re- 10,000 to 20,000 psi.
For convenience in manu- ceive the explosion transferred across a large air facturing, pellets are often preformed and then gap. Subsequently, they initiate a detonator. reconsolidated in the cup. Tetryl and RDX are A typical Relay, the XM11, is shown in Fig. the mobt common explosives for leads. 4-8. It has a closing disk of onion skin on the Because leads are used to transmit detonation input end to contain the explosive but not to waves, their size and shape might conveniently interfere with picking up a small explosive be set by the configuration of the fuze; i.e., the stimulus.
diameter is nearly equal to the preceding com- 0095 in ponent and the length depends on the distance between preceding and succeeding components. However, most efficient functioning is obtained by properly designing the lead just as any other upon explosive density, confinement, length, and diameter. A common length to diameter Iratio is 1 to 1. The effectiveness of the lead de- /flot LEAD AZIDE fou fe pends upon its in.iating the next component - CHARGE --- (booster charge) over a sufficient area so that it too will form a stable detonation. Some con- OSK figurations demand duplicate leads so as to as- sure reliable initiation of the booster charge.
4-4.4 BOOSTER CHARGES CUP '--"4 -The booster charge completes the fuze explo- sive train. It contains more explosive mate,,4 Figure 4-8. Retry, XM11 than any other element in the train. The booster 4-10