Connecting Accessories NOTICE Do not use the device to control or power a winch. Failure to follow this notice could cause damage to your vehicle or your device. Do not connect a power source to an accessory output terminal. Failure to follow this notice could cause damage to your vehicle or your device. Accessory requirements: Verify the amperage rating of each accessory before wiring it to the | device. The device supports accessories up to 30 A for each channel and a maximum of 100 A for the entire system. Use 10 AWG (6 mm 2 ) wires for accessories that use 20 to 30 A. Use 12 AWG (4 mm 2 ) wires for accessories that use 10 to 20 A.
Use 14 AWG (2.5 mm 2 ) wires for accessories that use less than 10 A. Use the appropriate size terminals for all accessory connections. Crimp all terminal connectors securely. 1 Connect the positive wire from the accessory | to one of the accessory terminals | on the | device. 2 Connect the negative or ground wire to an unpainted ground stud on the vehicle frame, to a ground distribution block or directly to the negative terminal on the battery. NOTICE Do not connect the accessory ground wires to the ground terminal (GND) on the | device. Failure to heed this notice could result in personal or property damage or negatively impact device functionality.
3 Verify that all electrical connections are tight and will not come loose during use. Connecting a Control Input You can connect to the control terminals to enable the Garmin PowerSwitch device to turn on customisable outputs. For example, you can connect your vehicle ignition switch to a control input terminal to turn on accessories automatically each time you start your vehicle. The control terminals detect a signal from 3.3 V to 18 V. You can configure output functions with the Garmin PowerSwitch app. Connect the control wire from the control source in your vehicle to one of the two control terminals on the Garmin PowerSwitch device. 68 Appendix