25. When the Front Panel displays the following message, check that all the Ink cartridges are correctly installed. Press any key to continue. 26. The Printer will continue with the ISS Communication test and the following messages will be displayed on the Front Panel: • Starting ISS Ink Sup. If there is a failure at this point, the Front Panel will display System Error Code 01.2:10 (refer to page 48) or System Error Code 01.0:10 (refer to page 47). • Getting ISS data. • Checking ISS Ink Sup. 27. Once the test is completed, OK will be displayed on the Front Panel. 4. Carriage Assembly Test The purpose of this test is to verify the operation of the Carriage Assembly. NOTE:
IF POSSIBLE ALWAYS PERFORM THIS TEST BEFORE REPLACING THE CARRIAGE ASSEMBLY. IF THIS TEST PASSES, DO NOT REPLACE THE CARRIAGE ASSEMBLY. Perform the Carriage Assembly test as follows: 1. In the Service Tests submenu, scroll to “4. Carriage Assembly Test” and press Enter . Tests and Utilities 2. This test has not yet been implemented. 5. Sensors Test The purpose of this test is to verify the operation of the following Sensors: • Window Position Sensor. • Media Lever. • Maintenance Cartridge Door Sensor. 112 Chapter 4 Service Tests and Utilities