Print OMAS Calibration Pattern 1. In the OMAS Calibration submenu, scroll to “Print Calibration Pattern” and press Enter . 2. When the following message appears on the front panel, you must select whether you would like to continue with the calibration by pressing the Enter key. Press Back or Cancel to exit the calibration. 3. If media is already loaded, the following message appears on the front panel and the media is unloaded. 4. If the media cannot be unloaded automatically, the Front Panel will show the following message. 5. Follow the instructions and unload the media. 6. The Front Panel prompts you to load media. NOTE:
During this calibration process you have to load the media with the Carriage positioned in the print path. Service Calibrations 168 Chapter 5 Service Calibrations