4. Clean the Cutter ramp with the damp cloth. 5. Clean the exposed part of the wheels with a dry cloth. Ideally, clean the whole circumference of these wheels (you can use Turn Drive Roller Utility on page 134). Clean the Encoder Strip Cleaning the Encoder Strip is a vital part of the printer’s maintenance and can clear a variety of system errors: • 86:01 or 87:01sytem errors and related mis positioning of the Carriage Assembly errors, such as the carriage bumping into the side of the printer.
Preventive Maintenance • 42:10 system error, related to failures starting and homing the carriage on the scan axis • 29:01 and 29:02 system errors which cannot be cleared even after installing new Maintenance Cartridges. • There are occasions when an encoder Strip that needs cleaning can cause media loading issues as the Carriage cannot correctly detect the position of the loading media. The front panel message With the type of pigmented ink that is used in the printer, the Encoder Strip cleaning must be performed at regular intervals. Cleaning must be performed after every 10 liters of ink used. The Front Panel will display a message when cleaning is required:
This message is displayed after every 5th job until the cleaning is performed, and the counter has been reset. This procedure is normally performed by the customer. Instructions and materials are provided within the User Maintenance kit. A kit is provided with each printer shipment. The kit can also be ordered using customer part 454 Chapter 9 Preventive Maintenance