• Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the power cord and power On the Printer. • Check that the Scan-Axis Motor cable is not damaged and is correctly connected to the PrintMech PCA. • Clean the Encoder Strip using a lint free cloth dampened with tap water, then reset the counter (Setup > Resets > Encoder cleaning) ⇒ See the instructions provided in the User Maintenance Kit and ⇒ Page 454 • Replace the Scan-Axis Motor ⇒ Page 346. • If the System Error continues, replace the PrintMech PCA ⇒ Page 384 System Error: System Error Codes 43:10 Problem Description: Vacuum Fan Sstopped. Corrective Action: Try the following:
• Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the power cord and power On the Printer. • Check that the Vacuum Fan cbles are not damaged and are correctly connected to the Interconnect PCA. • Also check that the cables between the Interconnect PCA and the PrintMech PCA are not damaged and are correctly connected. • Replace the Interconnect PCA ⇒ Page 357. • Replace the Vacuum Fan ⇒ Page 304. • If the System Error continues, replace the PrintMech PCA ⇒ Page 384 System Error: 44:10 Problem Description: Problem with the Aerosol Fan. Corrective Action: Try the following:
• Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the power cord and power On the Printer. • Check that the Aerosol Fan cable is not damaged and is correctly connected to the Interconnect PCA. • Replace the Aerosol Fan ⇒ Page 300. • If the System Error continues, replace the Interconnect PCA ⇒ Page 357. System Error: 44:11 Continuable and Non-Continuable Error Codes 61