Supermicro H8DC8/H8DCi — Supermicro H8DC8/H8DCi Motherboard User & Service Manual PDF

H8DC8/H8DCi User's Manual Power LED/Speaker On JD1, pins 1, 2, and 3 are for the power LED and pins 4 through 7 are for the speaker. See the tables on the right for pin defi nitions. Note: The speaker connector pins are for use with an external speaker. If you wish to use the onboard speaker, you should close pins 6 and 7 with a jumper. ATX PS/2 Keyboard and PS/2 Mouse Ports The ATX PS/2 keyboard and the PS/2 mouse ports are located at J101. The mouse is the top (green) port. See the table on the right for pin defi nitions. Chassis Intrusion A Chassis Intrusion header is located at JL1. Attach the appropriate cable to inform you of a chassis intrusion.

See the table on the right for pin defi nitions. Overheat LED Connect an LED to the JOH1 header to provide warning of chassis over- heating. See the table on the right for pin defi nitions. 2-12 PWR LED Connector Pin Defi nitions (JD1) Pin# Defi nition 1 +Vcc 2 Control 3 Control Speaker Connector Pin Defi nitions (JD1) Pin# Defi nition 4 Red wire, +5V 5 No connection 6 Buzzer signal 7 Speaker data PS/2 Keyboard and Mouse Port Pin Defi nitions (J101) Pin# Defi nition 1 Data 2 NC 3 Ground 4 VCC 5 Clock 6 NC Chassis Intrusion Pin Defi nitions (JL1) Pin# Defi nition 1 Battery voltage 2 Intrusion signal Overheat LED Pin Defi nitions (JOH1) Pin# Defi nition 1 3.3V 2 OH Active