Supermicro H8DC8/H8DCi — Supermicro H8DC8/H8DCi Motherboard User & Service Manual PDF

H8DC8/H8DCi User's Manual DMA Mode Selects the DAM Mode. Options are SWDMA0, SWDMA1, SWDMA2, MWDMA0. MDWDMA1, MWDMA2, UDMA0. UDMA1, UDMA2, UDMA3, UDMA4 and UDMA5. (SWDMA=Single Word DMA, MWDMA=Multi Word DMA, UDMA=UltraDMA.) S.M.A.R.T. Self-Monitoring Analysis and Reporting Technology (SMART) can help predict impending drive failures. Select "Auto" to allow BIOS to auto detect hard disk drive support. Select "Disabled" to prevent AMI BIOS from using the S.M.A.R.T. Select "Enabled" to allow AMI BIOS to use the S.M.A.R.T. to support hard drive disk. The options are Disabled, Enabled, and Auto . 32-Bit Data Transfer Select "Enabled" to activate the function of 32-Bit data transfer.

Select "Disabled" to deactivate the function. The options are Enabled and Disabled . Hard Disk Write Protect Select Enabled to enable the function of Hard Disk Write Protect to prevent data from being written to HDD. The options are Enabled or Disabled . IDE Detect Time Out (Sec) This feature allows the user to set the time-out value for detecting ATA, ATA PI devices installed in the system. The options are 0 (sec), 5, 10, 15, 20, 25, 30 and 35 . ATA(PI) 80Pin Cable Detection This setting allows AMI BIOS to auto-detect the 80-Pin ATA(PI) cable. The options are Host, Device and Host & Device . SATA0 IDE Interface This setting is used to Enable or Disable the serial controller for SATA0.

SATA1 IDE Interface This setting is used to Enable or Disable the serial controller for SATA1. First Boot Device From Use this setting to select the fi rst boot device as being P-ATA or S-ATA. 4-4