Chapter 2: Installation JIPMB1 (H8DCL-6/iF only) A System Management Bus header for the IPMI slot is located at IPMB. Connect the appropriate cable here to use the IPMB I2C connection on your system. LAN1/2 (Ethernet Ports) Two Gigabit Ethernet ports (designated LAN1 and LAN2) are located beside the VGA port. Additionally, for the H8DCL-iF and H8DCL-6F serverboards, there is a dedicated LAN for IPMI on top of the two rear USB ports. These Ethernet ports accept RJ45 type cables. Note: NC indicates no connection. Overheat LED Connect an LED to the JOH1 header to provide warning of chassis overheating. See the table on the right for pin defi nitions.
Compact Flash Card PWR Connector Two Compact Flash Card Power Connector is located at JWF1. For the Compact Flash Card to work properly, you will need to enable with JCF1 and connect a Compact Flash Card power cable to JWF1. 2-17 JIPMB1 Pin Defi nitions Pin# Defi nition 1 Data 2 Ground 3 Clock 4 No Connection LAN Ports (LAN1/2) Pin Defi nition Pin# Defi nition Pin# Defi nition 1 P2V5SB 10 SGND 2 TD0+ 11 Act LED 3 TD0- 12 P3V3SB 4 TD1+ 13 Link 100 LED (Yellow, +3V3SB) 5 TD1- 14 Link 1000 LED (Yellow, +3V3SB) 6 TD2+ 15 Ground 7 TD2- 16 Ground 8 TD3+ 17 Ground 9 TD3- 18 Ground Overheat LED Pin Defi nitions (JOH1) Pin# Defi nition 1 3.3V 2 OH Active