Supermicro H8DMT/H8DMT-F — Enabling SATA RAID in the BIOS

H8DMT/H8DMT-IBX/H8DMT-F/H8DMT-IBXF User’s Manual Installing the OS/SATA Driver Before installing the OS (operating system) and SATA RAID driver, you must decide if you wish to have the operating system installed as part of a bootable RAID array or installed to a separate non-RAID hard drive. If on a separate drive, you may install the driver either during or after the OS installation. If you wish to have the OS on a SATA RAID array, you must follow the procedure below and install the driver during the OS installation. You must first build a driver diskette from the Supermicro CD-ROM that was included with the system.

(You will have to create this disk on a computer that is already running and with the OS installed.) Building a Driver Diskette 1. Insert the CD into your CD-ROM drive and start the system. A display as shown in Figure 2-10 will appear. 2. Click on the icon labeled B UILD D RIVER D ISKETTES AND M ANUALS and follow the instructions to create a floppy disk with the driver on it. 3. Once it's been created, remove the floppy and insert the installation CD for the Windows Operating System you wish to install into the CD-ROM drive of the new system you are about to configure. Before installing the Windows Operating System, you must change some settings in the BIOS.

Boot up the system and hit the EL > key to enter the BIOS Setup Utility. After the Setup Utility loads, do the following: Enabling SATA RAID in the BIOS 1. Use the arrow keys to move to the E XIT menu. Scroll down with the arrow keys to the L OAD O PTIMAL D EFAULTS setting and press NTER >. Select OK to confirm, then NTER > to load the default settings. 2. Use the arrow keys to move to the A DVANCED menu, then scroll down to N V IDIA RAID S ETUP and press the NTER > key. 3. Once in the submenu, scroll down to N V IDIA RAID F UNCTION and enable the setting, which will cause the SATA0/1/2 P RIMARY /S ECONDARY settings to appear. Enable the SATA devices and channels you will be using. 4.

Hit the SC > key twice and scroll to the E XIT menu. Select S AVE C HANGES AND E XIT , then hit NTER >, then hit NTER > again to verify. 5. After exiting the BIOS Setup Utility, the system will reboot. When prompted during the startup, press the key when prompted to run the nVidia RAID Utility program. 2-18