Supermicro H8DMT/H8DMT-F — Table 4-2. SATA Configuration Submenu

Chapter 4: BIOS Table 4-1. BIOS Features Submenu (Continued) Table 4-2. SATA Configuration Submenu 4-3 Menu Item Description WHEA Support Use this setting to Enable or DISABLE WHEA (Windows Hardware Error Architecture) support. WHEA provides a common infrastructure for reporting hardware errors on Windows platforms and was designed to improve recovery following fatal hardware errors. Power Button Mode Allows the user to change the function of the power button. Options are On/Off and SUSPEND. Watch Dog Timer Select This setting is used to ENABLE or Disable the Watch Dog Timer function. It must be used in conjunction with the Watch Dog jumper (see Chapter 2 for details).

To enable, choose from 1, 2, 3, 4, 8, 15 or 30 MIN. Restore on AC Power Loss This setting allows you to choose how the system will react when power returns after an unexpected loss of power. The options are POWER OFF, POWER ON and Last State. MPS Revision This setting allows the user to select the MPS (MultiProcessor Specification) revision level. The options are 1.1 and 1.4. Menu Item Description Serial ATA Devices This setting is used to determine if SATA drives will be used and how many. Options are DISABLED, DEVICE 0 and Device 0/1. nVidia RAID Function This setting is used to ENABLE or Disable the nVidia ROM. If enabled, the setting below will appear.

XSerialATA 0/1 Primary/Secondary Channel This setting is used to ENABLE or Disable the SATA0 Primary, SATA0 Secondary, SATA1 Primary and SATA1 Secondary, channels (four settings total). If enabled, the following settings will appear: LBA/Large Mode LBA (Logical Block Addressing) is a method of addressing data on a disk drive. The options are DISABLED and Auto. Block (Multi-Sector Transfer) Block mode boosts IDE drive performance by increasing the amount of data transferred. Only 512 bytes of data can be transferred per interrupt if block mode is not used. Block mode allows transfers of up to 64 KB per interrupt.

Select DISABLED to allow the data to be transferred from and to the device one sector at a time. Select Auto to allows the data transfer from and to the device occur multiple sectors at a time if the device supports it. The options are Auto and DISABLED.