H8DMT/H8DMT-IBX/H8DMT-F/H8DMT-IBXF User’s Manual Table 4-2. SATA Configuration Submenu (Continued) Table 4-3. PCI/PnP Configuration Submenu 4-4 Menu Item Description PIO Mode PIO (Programmable I/O) mode programs timing cycles between the IDE drive and the programmable IDE controller. As the PIO mode increases, the cycle time decreases. The options are Auto, 0, 1, 2, 3, and 4. Select Auto to allow BIOS to auto detect the PIO mode. Use this value if the IDE disk drive support cannot be determined. • Select 0 to allow BIOS to use PIO mode 0, which has a data transfer rate of 3.3 MBs. • Select 1 to allow BIOS to use PIO mode 1, which has a data transfer rate of 5.2 MBs.
• Select 2 to allow BIOS to use PIO mode 2, which has a data transfer rate of 8.3 MBs. • Select 3 to allow BIOS to use PIO mode 3, which has a data transfer rate of 11.1 MBs. • Select 4 to allow BIOS to use PIO mode 4, which has a data transfer rate of 16.6 MBs. This setting generally works with all hard disk drives manufactured after 1999. For other disk drives, such as IDE CD-ROM drives, check the specifications of the drive. DMA Mode Selects the DMA Mode. Options are Auto, SWDMA0, SWDMA1, SWDMA2, MWDMA0. MDWDMA1, MWDMA2, UDMA0. UDMA1, UDMA2, UDMA3, UDMA4 and UDMA5. (SWDMA=Single Word DMA, MWDMA=Multi Word DMA, UDMA=UltraDMA. S.M.A.R.T.
Self-Monitoring Analysis and Reporting Technology (SMART) can help predict impending drive failures. Select Auto to allow BIOS to auto detect hard disk drive support. Select "Disabled" to prevent AMI BIOS from using the S.M.A.R.T. Select ENABLED to allow AMI BIOS to use the S.M.A.R.T. to support hard drive disk. The options are DISABLED, ENABLED, and Auto. 32-Bit Data Transfer Select Enabled to activate the 32-Bit Data Transfer function. Select DISABLED to deactivate the function. The options are Enabled and DISABLED. Menu Item Description Slot 1 OPROM Use this setting to enable or disable the OPROM (Option ROM firmware) for slot 1. The options are Yes and NO.
Load Onboard LAN Option ROM Use this setting to ENABLE or Disable the onboard option ROM. This setting must be enabled to view the BOOT MENU settings. Clear NVRAM Select YES to clear NVRAM (Non-Volatile Random Access Memory) during boot-up. The options are YES and No. Plug & Play OS Select YES to allow the OS to configure Plug & Play devices. (This is not required for system boot if your system has an OS that supports Plug & Play.) Select No to allow AMIBIOS to configure all devices in the system. PCI Latency Timer This option sets the latency of all PCI devices on the PCI bus. Select a value to set the PCI latency in PCI clock cycles. Options are 32, 64, 96, 128, 160, 192, 224 and 248.