Supermicro H8DMT/H8DMT-F — Table 4-12. IPMI Configuration

H8DMT/H8DMT-IBX/H8DMT-F/H8DMT-IBXF User’s Manual Table 4-11. Hardware Health Monitor Submenu Table 4-12. IPMI Configuration 4-8 Menu Item Description CPU Overheat Alarm Use the "+" and "-" keys to set the CPU temperature threshold to between 65o and 90o C. When this threshold is exceeded, the overheat LED on the chassis will light up and an alarm will sound. The LED and alarm will turn off once the CPU temperature has dropped to 5 degrees below the threshold set. The default setting is 72o C. XSystem Fan Monitor Submenu Fan Speed Control This feature allows you to determine how the system will control the speed of the onboard fans. Select WORKSTATION if your system is used as a Workstation.

Select SERVER if your system is used as a server. Select Disable to disable the fan speed control function to allow the onboard fans to continuously run at full speed (12V). The options are 1) Disable (Full Speed) 2) 3-PIN (SERVER) and 3) 3-PIN (WORKSTATION). FAN1 Speed through FAN4 Reading The speeds of the onboard fans (in rpm) are displayed here. Other Information Other items in the submenu are systems monitor displays for the following information: CPU1 TEMPERATURE, CPU2 TEMPERATURE (for 2U systems), SYSTEM TEMPERATURE, VCOREA, VCOREB (for 2U systems), HT VOLTAGE, CPU1 MEM VTT, CPU2 MEM VTT, CPU1 MEM, CPU2 MEM, 12V, 3.3V, VDD, 5V VSB, MCP55VCORE, 1.5V and VBAT.

Menu Item Description X View BMC System Event Log Use the "+" and "-" keys to navigate through the system event log. Pressing the Enter key will open the following setting: Clear BMC System Event Log Selecting this and pressing the Enter key will clear the BMC system event log. X Set LAN Configuration Use the "+" and "-" keys to choose the desired channel number. X IP Address Use the "+" and "-" keys to select the parameter. The IP address and current IP address in the BMC are shown. X MAC Address Use the "+" and "-" keys to select the parameter. The MAC address and current MAC address in the BMC are shown. X Subnet Mask Use the "+" and "-" keys to select the parameter.

The subnet address and current subnet address in the BMC are shown. X Set PEF Configuration Submenu PEF Support Use this setting to ENABLE or Disable PEF support. When enabled, the following settings will appear: BMC Watch Dog Timer Action This setting is used to set the Watch Dog function. The options are Disabled, RESET SYSTEM, POWER DOWN and POWER CYCLE.