Chapter 4: BIOS Table 4-8. I/O Device Configuration Submenu Table 4-9. DMI Event Logging Submenu Table 4-10. Console Redirection Submenu 4-7 Menu Item Description Serial Port1 Address This option specifies the base I/O port address and Interrupt Request address of serial port 1. The options are DISABLED, 3F8/IRQ4, 3E8/IRQ4 and 2E8/IRQ3. Select DISABLED to prevent the serial port from accessing any system resources. When this option is set to DISABLED, the serial port physically becomes unavailable. Select 3F8/IRQ4 to allow the serial port to use 3F8 as its I/O port address and IRQ 4 for the interrupt address.
Serial Port2 Address This option specifies the base I/O port address and Interrupt Request address of serial port 2. The options are DISABLED, 2F8/IRQ3, 3E8/IRQ4 and 2E8/IRQ3. Select DISABLED to prevent the serial port from accessing any system resources. When this option is set to DISABLED, the serial port physically becomes unavailable. Select 2F8/IRQ3 to allow the serial port to use 2F8 as its I/O port address and IRQ 3 for the interrupt address. Menu Item Description View Event Log Highlight this item and press to view the contents of the event log. Mark All Events as Read Highlight this item and press to mark all events as read.
Clear Event Log Select Yes and press to clear all event logs. The options are YES and NO to verify. Menu Item Description Remote Access Allows you to ENABLE or Disable remote access. If enabled, the settings below will appear: Serial Port Number Selects the serial port to use for console redirection. Options are COM1 and COM2. Serial Port Mode Selects the serial port settings to use. Options are (115200 8, n, 1), (57600 8, N, 1), (38400 8, N, 1), (19200 8, N, 1) and (09600 8, N, 1). Flow Control Selects the flow control to be used for console redirection. Options are None, HARDWARE and SOFTWARE.
Redirection After BIOS POST Options are DISABLE (no redirection after BIOS POST), BOOT LOADER (redirection during POST and during boot loader) and Always (redirection always active). Note that some OS's may not work with this set to ALWAYS. Terminal Type Selects the type of the target terminal. Options are ANSI, VT100 and VT-UTF8. VT-UTF8 Combo Key Support Allows you to Enable or DISABLE VT-UTF8 combination key support for ANSI/ VT100 terminals. Sredir Memory Display Delay Use this setting to set the delay in seconds to display memory information. Options are No Delay, 1 SEC, 2 SECS and 4 SECS.