omron — APPENDIX F Serial Commands

F Serial Commands QUERYFOCUSUNITS Queries the units being used for autofocus, mm (0) or inches (1). QUERYWHITEBAL Returns white balance settings: RED gain, BLUE gain, and GREEN gain. QUICKFOCUS [x] [y] Performs an autofocus by analyzing the area around the point specified by x and y . The response is in the format of the camera’s current focus, min. allowable focus on the camera, max. allowable focus on the camera. Example: Perform a quick focus on point (640,480) in the image. Command: QUICKFOCUS 640 480 Response: 124;50;300 (Current focus is set to 124 mm with an allowable focus range of 50 – 300 mm on the current camera.) Important: This command only functions when the camera is OFFLINE.

READY? [-insp=n] Queries if inspection is waiting for a trigger. !1 if all inspections are ready or !0 if not all inspections are ready. -insp=n specifies the inspection to query if it is ready. REBOOT [-noload] Reboots the device. -noload = do not load BOOT job. RESTOREWBAL Restores preset white balance parameters: RED gain, BLUE gain, and GREEN gain. HAWK MV-4000 Smart Camera Guide F-7